[600MRG] No decode with WSPR

[Brian Pease]

Be sure you are on USB, not LSB.  Your 578-817Hz display is typical.  If 
the signals are contained withing the 2 minute time slots, they should 
decode right dow to where they can barely be seen.  If all else fails, 
re-install WSPR 2.11.

On 3/27/2015 1:42 AM, Dick Illman wrote:
> Hi 630m group.
>
> I have been trying to decode WSPR on the 472-479 band. My dial
> frequency of 474.2 is within 3hz. I have tried selecting the 600m band
> and other, and then typing in the recommended 474.2. My time is within
> .1s and the indicated rx noise is set to 0dB. I am seeing (and
> hearing) signals but no decode. For reasons I do not understand the
> frequency display shows 578-817Hz. There is a signal that shows 1531hz
> on the FRlex1500 but it shows about 730 on the WSPR display. I am
> using a Rig Blaster Advantage USB sound card.
>
> I am obviously doing something wrong. Any ideas?
>