[600MRG] building the ultimate regenerative receiver

[Dave Riley]

Here sits an RAK in brand new condition which was easily modified to 9V 
battery use with a hand full of resistors, caps, and mpf102s tack 
soldered in place, just remove for original condition...

I left the tubes in their sockets to keep that wonderful piece of 
mechanical and electronic engineering tracking and looking as built...

Being a real ham I found it easy to drill two holes in the front panel 
which accommodate BNC connectors...

Now it is not only a VLF+ receiver but those bnc connectors look at the 
in and out of the TRF part and makes a wunnerful pre-selector...

Life is good!!  It even heard SAQ...

DaveR @ aa1a


On 2/26/2018 10:48 PM, kl7aj at acsalaska.net wrote:
> I've always had a regenerative receiver or two lying around the shack. Since I'm getting into 630 meters, I thought I'd build a new regen for that band, just for jollies.
>
> Contrary to a lot of literature out there, all regenerative receivers are not the same. Some of the newer versions, such as MFJ's are pretty good, but there's room for improvement. A lot of the later designs are based on the assumption that "a little positive feedback covers a multitude of sins." While true in theory (the autodyne function is indeed capable of infinite gain and sensitivity, regardless of the open loop parameters), in practice this is not the case. After playing around with a LOT of regen receiver designs, here are two truths that make all the difference in performance.
>
> 1) Use the HIGHEST Q tank circuit possible. Do NOT rely entirely on "Q-multiplication" to make this work. A decent regen receiver will work "reasonably well" without any regeneration.
>
> 2) Design the RF amplifier to have the highest OPEN LOOP gain possible. You only need a gain of slightly more than 1 to make an oscillator oscillate....this is NOT the best idea for a regen receiver. Again, the receiver should work "fairly well" before adding any feedback/regeneration. In an attempt to make modern regens "user friendly" i.e., not touchy, manufacturers have been using gain control, such as by adjusting the bias or adjusting the emitter resistor value, to created some degeneration. This practice SERIOUSLY degrades performance. The old school "tickler coil" method for adjusting regeneration is STILL the superior method....by a long shot. Yes, it's touchy....but when you get the hang of it, the magical regen performance of ages past really comes to life.
>
> In the near future, I will present some oscilloscope shots of my optimized 630 meter regen.
> Stay tuned!
>
> Eric
> ---
> Eric P. Nichols, KL7AJ
> AlasKit Educational and Scientific Resources
> 3763 Lyle Avenue
> North Pole, AK 99705
> (907) 488-0483
> (907) 371-7120
> http://alaskit.co
> _______________________________________________
> 600MRG mailing list
> 600MRG at w7ekb.com
> http://w7ekb.com/mailman/listinfo/600mrg_w7ekb.com
>