[600MRG] Fwd: K3 transverter operation

[Eric NO3M]

These settings should work:

XV1 ON = YES
XV1 RF = 0
XV1 IF = 10
XV1 PWR = L1.50
XV1 OFS = 0.00
XV1 ADR = trn1

After setting, exit menu and go to the first transverter band, which is 
between 160 and 6M.

Don't try to directly enter frequencies, doesn't work and ends up 
putting radio on 160M, exiting the transverter band.

73 Eric NO3M

On 05/04/2014 07:21 PM, Pat Bunn wrote:
>> From: Pat Bunn <pbunn at matrixei.com>
>> Date: May 4, 2014, 7:13:52 PM EDT
>> To: Eric NO3M <no3m at no3m.net>
>> Subject: Re: [600MRG] K3 transverter operation
>>
>> I loaded the latest firmware into my K3( been a long time since it was updated) and have been struggling to get the transverter interface to work.
>>
>> I have set the configuration as the manual says and turned the interface to normal. The if is set to 10 MHz and the power to 1.5 mW but when I key it I get a 10 watt  10 MHz signal at the main antenna and nothing at the transverter out jack.
>>
>> Anyone out there with a K 3 have any idea what I am doing wrong?
>>
>> Pat
>> Xct
>>
>>
>>
>>
>>