[600MRG] Coil tap clip

[Merv Schweigert]

Right Bill,

The coil is from some very large LF gear,  its actually a variac, 8 inch 
diameter and
14 inch log.  wound with 1/4 inch plated copper ribbon.  has a large 
variable coil
inside, close to one end with a shaft to turn it of course.
Need to tap the coil to resonate my 160 meter vertical on 475KHZ. and a 
tap to feed
power to the coil up from the ground end.
Have some roller coils good for many many KW but they are not large 
enough inductance
wise.

Years back would sure liked to have had a bag full of the coil clips for 
antenna tuners
and open wire line I was using.
Merv

> Hi Merv,
>
> I have seen those "ribbon wire" inductors. The clips I have (even if 
> they were available) would be like a chihuahua dog (tea cup size) 
> biting a full size, salt water crocodile! It probably would hang on 
> very long. But it's still good to know where I can get the clips.
>
> 73,
>
> Bill  KU8H
>
>
>
> On 12/13/2014 07:28 PM, Merv Schweigert wrote:
>> Yes see the coil clip from B&W, for coil stock,  nice,
>> Need a larger one for flat ribbon stock,  more like a
>> 10 amp or larger current size one.
>> Old broadcast gear had them ..
>> Merv
>>
>
>
> _______________________________________________
> 600MRG mailing list
> 600MRG at w7ekb.com
> http://w7ekb.com/mailman/listinfo/600mrg_w7ekb.com
>